XH Motorcycles Forum

Motorcycle Resource Forums => Technical Resource Discussion => Topic started by: Erik-Minnesota on February 06, 2017, 04:48:29 PM

Title: Cover Up That Ugly Bolt ! For Cheap !
Post by: Erik-Minnesota on February 06, 2017, 04:48:29 PM
Cover Up That Ugly Bolt ! For Cheap !

Found this and it works great ! And Cheap !
A little 3m double sided tape and you are looking great !

https://www.menards.com/main/plumbing/rough-plumbing/plumbing-installation-repair/sink-accessories/plumb-works-snap-in-faucet-hole-cover/p-1444437561724-c-9417.htm?tid=-9042888583565592111 (https://www.menards.com/main/plumbing/rough-plumbing/plumbing-installation-repair/sink-accessories/plumb-works-snap-in-faucet-hole-cover/p-1444437561724-c-9417.htm?tid=-9042888583565592111)

http://www.homedepot.com/p/Elkay-Kitchen-Sink-Faucet-Hole-Cover-in-Chrome-LK125R/202266945 (http://www.homedepot.com/p/Elkay-Kitchen-Sink-Faucet-Hole-Cover-in-Chrome-LK125R/202266945)
Title: Re: Cover Up That Ugly Bolt ! For Cheap !
Post by: wytfut on February 06, 2017, 05:08:44 PM
Jamie/Marty also sell a stainless steel machined cap for that very same nut. It's very old looking.
Hot toppers used to sell a kit specially packaged for EH...   I just saw a few eBay lines selling hot toppers enteric or HD kits...
And I found out a year ago that McMaster Carr sell dust covers for fasteners Madeira SS....  And that's also nice look. Really cheap!!!

Bruce
Title: Re: Cover Up That Ugly Bolt ! For Cheap !
Post by: Erik-Minnesota on February 07, 2017, 08:35:57 AM
Quote from: wytfut on February 06, 2017, 05:08:44 PM
And I found out a year ago that McMaster Carr sell dust covers for fasteners Madeira SS....  And that's also nice look. Really cheap!!!
Bruce

Yea looked a few and they all seemed to "stick out" Too much  :/
My Solution is Super Cheap and fits flat to the Nut ..
Title: Re: Cover Up That Ugly Bolt ! For Cheap !
Post by: Jumper on February 09, 2017, 01:31:29 PM
Hot Toppers look great... Until... Your tearing into a motor and try to remove and not break,,, Could go a different way and powder coat the nut and bolt a-la mono-chrome-a-tic...
Jumper