Cover Up That Ugly Bolt ! For Cheap !

[Erik-Minnesota]

Cover Up That Ugly Bolt ! For Cheap !

Found this and it works great ! And Cheap !
A little 3m double sided tape and you are looking great !

https://www.menards.com/main/plumbing/rough-plumbing/plumbing-installation-repair/sink-accessories/plumb-works-snap-in-faucet-hole-cover/p-1444437561724-c-9417.htm?tid=-9042888583565592111

http://www.homedepot.com/p/Elkay-Kitchen-Sink-Faucet-Hole-Cover-in-Chrome-LK125R/202266945

[wytfut]

Jamie/Marty also sell a stainless steel machined cap for that very same nut. It's very old looking.
Hot toppers used to sell a kit specially packaged for EH...   I just saw a few eBay lines selling hot toppers enteric or HD kits...
And I found out a year ago that McMaster Carr sell dust covers for fasteners Madeira SS....  And that's also nice look. Really cheap!!!

Bruce

[Erik-Minnesota]

And I found out a year ago that McMaster Carr sell dust covers for fasteners Madeira SS....  And that's also nice look. Really cheap!!!
Bruce

Yea looked a few and they all seemed to "stick out" Too much  :/
My Solution is Super Cheap and fits flat to the Nut ..

[Jumper]

Hot Toppers look great... Until... Your tearing into a motor and try to remove and not break,,, Could go a different way and powder coat the nut and bolt a-la mono-chrome-a-tic...
Jumper