« previous next »
Pages: [1]   Go Down

Author Topic: Floorboard to Peg Conversion  (Read 2122 times)

Offline brixtonanimal

  • XH Rider XXX
  • ***
  • Posts: 41
Floorboard to Peg Conversion
« on: May 16, 2019, 09:41:28 AM »
Has anybody swapped out the floorboards for pegs? I know that there are some JDM and Harley kits, but I'm wondering if they bolt straight up. Any thoughts would be appreciated
Logged

Offline brixtonanimal

  • XH Rider XXX
  • ***
  • Posts: 41
Re: Floorboard to Peg Conversion
« Reply #1 on: May 16, 2019, 09:49:26 AM »
This is what I was thinking. Not sure if the bolts would line up, but it looks very similar
Logged

Offline wytfut

  • XHRC Rider Moderator
  • XH Rider XXXXX
  • *****
  • Posts: 932
  • What goes around, comes around
    • Grandpa Grumpy Pants X world youtube
Re: Floorboard to Peg Conversion
« Reply #2 on: May 16, 2019, 06:51:45 PM »
You could ask around.... Someone may have a set of Xman forward controls, or Atlantic EH had some in the early days...   
Possible someone has a set sitting on the shelf...
Logged
Bruce
EH Rider X Moderator

Offline brixtonanimal

  • XH Rider XXX
  • ***
  • Posts: 41
Re: Floorboard to Peg Conversion
« Reply #3 on: May 17, 2019, 09:10:29 AM »
Do the forward controls bolt up to the stock floorboard position or are they further forward?
Logged

Offline wytfut

  • XHRC Rider Moderator
  • XH Rider XXXXX
  • *****
  • Posts: 932
  • What goes around, comes around
    • Grandpa Grumpy Pants X world youtube
Re: Floorboard to Peg Conversion
« Reply #4 on: May 17, 2019, 10:05:36 AM »
Jamie's (haven't made/sold them for years), didn't replace the pads if I remember right. Xmans you had to remove the pads.
Logged
Bruce
EH Rider X Moderator

Offline brixtonanimal

  • XH Rider XXX
  • ***
  • Posts: 41
Re: Floorboard to Peg Conversion
« Reply #5 on: May 17, 2019, 11:14:22 AM »
Thanks so much for the help!
Logged
Pages: [1]   Go Up
« previous next »